Loading... Please wait...
Shop By Categories
- Home
- Solenoid Valves
- Shut Off Solenoid Valve, 3/8", Aquatec
Shut Off Solenoid Valve, 3/8", Aquatec
Product Description
This normally closed solenoid valve is especially well suited for situations where power will be supplied to the solenoid for an extended time. It is ideal for use as a shut off solenoid on the feedwater tube for an RO or RODI system that may run for hours at a time. Use to control flow up to 2.5 gpm.
This 3/8" solenoid includes a wiring harness with two plugs compatible with Aquatec transformers, pumps, and other accessories. 24 VAC. Rated for 100% duty time. Max Pressure 100 psi. Includes 3/8" quick connect fittings. Proper flow direction is marked on the bottom of the valve. Wetted surfaces are polypropylene, EPDM, and Stainless Steel.
Product Reviews
-
Works as described
Posted by Russel Kubes on 31st Jan 2015
This product works as described. Not much to say about a solenoid valve.
One added benefit is where the quick connect fittings screw on to the valve body, there are actually washers inside. This means you don't have to mess around with Teflon tape on the threads. Very good seal.
Be aware that it is important to observe the marked direction of flow. This valve will allow backflow (water flowing in the opposite direction of the arrow) when it is closed if the back pressure is high enough. Thus, if you install the valve backwards it would not stop the flow.
If you are concerned about backflow (i.e. when you D/C the feed line while there's still pressure inside the housings), just install a check valve.
YOU MAY ALSO LIKE
Our Newsletter
Sign up for exclusive updates and special offers!
Shipping
Buckeye typcially ships the same day, or less commonly, the day after an order is placed. The majority of our shipments are sent UPS Ground or FedEx Ground. Estimated delivery times for these services are similar, and are shown below. See our policies page for additional shipping information.
Read More About ShippingFAQ
When should I replace my filters?
Will Buckeye filters fit properly in my water filtration system?
Do I need to do anything special when I install new cartridges in my RO or RO/DI system?
