The R13-1200 Reverse Osmosis System includes features typically reversed for much larger/expensive RO systems.  System pictured includes optional leg kit.  Features include:

• Powder coated steel frames
• Inlet solenoid valve
• Pre-filter
• 1/2 HP pump motor
• Brass pump
• Liquid-filled pre-filter pressure gauge
• 2 1/2” liquid filled pump pressure gauge
• Product water & reject water flow meters
• High pressure, non-metallic membrane housings
• Stainless needle valves for reject & recycle lines
• Stainless product water check valve
• On/Off toggle switch
• Low-pressure shut-off with auto restart
• Feed water and product water TDS monitor

Performance specifications are based on 77°F feed water, SDI <3, TDS below 1000 ppm, and pH of 8. Chlorine reduction and other
pretreatment may be required. Systems are designed for use with municipal and well water.

Specifications:
Feed water connection: 3/4" NPTF
Product water connection: 3/8” Tubing OD
Reject water connection: 3/8” Tubing OD
Feed water required (max.): 2.4 GPM
Feed water pressure (min.): 10 PSI
Drain required (max.): 2.4 GPM
Electrical requirements: 120 VAC 60 Hz
Current: 8 Amps
Pump: 1/2 Horsepower
Maximum production: 1200 gallons per day
Average membrane rejection rate: 96 to 98%
Recovery (adjustable): 34 to 75%
Membrane size: 3” x 20” nominal
Number of membranes: 2
Pre-filter: 20" x 2.5" x 5 micron melt blown polypropylene
Dimensions (W x H x D): 26” x 36” x 9”, nominal
Shipping Weight: apx. 75 lbs

This product ships freight.  Additional shipping fees will apply if a liftgate delivery is needed.